Sports Sedan Forum

Hey guys im looking for a rear wing to suit sports sedans, we currently run a Ford EL V8SC carbon wing which has some unrepairable damage and were looking for a replacement. Obviously doesn't have to be the same, but anything that conforms to the rules and preferably carbon. If anyone has any moulds or know of where we could source something suitable it would be greatly appreciated, cheers.

I have a duel plane carbon wing that I used to run on my EB falcon. It is up on the roof of the office at my shed.
It is in perfect condition and protected by several layers of dust.

The carbon end plates are with it, they bolted direct to the chassis. Both wings are adjustable via slides, just loosen bolts adjust and retighten.

I seem to remember it cost me about $2400 in 1996 so I think a fair ask today would be about $1,500 if you are interested.

Thanks Phast Phill, would you be able to give me the full width of the wing cords. I would like to fit the wing to the existing end plates.

I will have the measurement to you early in the week as the builders have been in extending the Mezz floor and I cannot get to it yet.

Cheers
Phil

I measured it today and I forgot to write it down but I am sure it was 1480mm
Is that in your ball park Tassie RS?
If so call me on 0411 740 092

Hey Phast Phil,
:pAre you sure it is not about 1829mm long? :p


toranaracer

Thanks Phill for taking the time to measure the wing, but it is 100mm too short. Hope I can have a new wing made by the first round but its not looking good. Will have to repair the old one for now.